User's Manual

Wireless Access Point User manual
Page 21 of 36
Figure 20
z System Information: This section shows the installed version of the
firmware of the Wireless AP. And company information.
Figure 21
6.3 LAN Setup
The Wireless Access Point communicates with the wired/wireless clients
through its LAN port. The LAN configuration page allows you to define the
private IP address settings over the LAN interface.
Figure 22
z IP Address/Subnet Mask/Gateway: Enter the IP address, Subnet
mask and Gateway for the Wireless Access Point LAN port. All local
wired/wireless devices communicate with the device through this port. It is
also the IP address of the Web-based Configuration Utility. By default, the
IP address, Subnet mask and Gateway of the LAN port is 192.168.1.1,
255.255.255.0 and 0.0.0.0 respectively.
z Click “Apply” when you have finished the configuration above. And the
wireless AP will be automatically restarted if you change the LAN IP