User's Manual

ADSL2+ModemRouterUserManual

36

4.3.3.1BasicSettings

GotoSetup‐>WLAN‐>Basicpage,youcanconfigurethewirelessparameters.



Here you may enable or disable the wireless function. You can also change the wireless

parameters, such as Band, SSID, Channel Width, Control Sideband, Channel Number and Radio

Power.



Band:Inthedrop‐downlistyoucanselectthebandtype.Forexample:2.4Gb+g+nallows2.4G

802.11b,802.11gand802.1

1nwirelessclientstoconnecttothiswirelessModemRouter.

Mode:Inthedrop‐downlist,youcanselectAPorAP+WDS,whichallowswirelessstationto

associatewithAPorAP+WDS.

ChannelNumber:

Selectthechannelyouwanttousefromthedrop‐downListofchannel.This

fielddetermineswhichoperatingfrequencywillbeused.Itisnotnecessarytochangethewireless

channelunlessyounoticeinterferenceproblemswithanothernearbyaccesspoint.



ChannelWidth: SelecttheChannelWidthyouwanttousefromthedrop‐downList.Ifbigger

bandwidthisselected,devicecouldtrans

mitandreceivedatawithhigherspeed.