User's Manual

8
clickAdd”
Fourth:Click“Save”bottontomak eiteffetive.
Figure9
5. Wireless Network&Security
To connect to the Wireless AP, we should have the most basic
configuration of the router at first. In this section, you can set the
9
wireless network parameters required to access the AP of your WLAN
interface.
Go to Setup->WLAN->Basic page, you can configure the wireless
parameters.
Here you may enable or disable the wireless function. You can also
change the wireless parameters, such as Band, SSID, Channel Width,
Control Sideband, Channel Number and Radio Power.
Figure10
Step 2:Go to Setup->WLAN->Security page, you can configure the
wireless security parameters.
10
Here you can choose the encryption method to prevent any
unauthorized access to your wireless network.
There are three most commonly used encryption method (a total of six
encryption support), including the WEP encryption, WPA-Personal,
WPA2-Personal, etc.
Click “Apply Changes” to make it effective
Figure11
Step 3: Click “My Network Places” with the right button of your
mouse.ThenselectProperties”.
Step 4:
C
ofyour
m
Step5:
D
C
lick Wireles
s
m
ouse.Thens
D
oubleclickth
e
11
Figure1
s
Network Con
e
lectViewAv
a
Figure1
e
wirelessnetw
2
nection with
a
ilableWireles
s
3
orkyourprodu
the right butt
o
s
Networks”.
ctprovided.
o
n