User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Monitor the Switch and Network User Manual650
any collectors or relays. When the syslog Admin Status is enabled, messages are sent to
configured collectors or relays using the values configured for each collector or relay.
6. Use Local UDP Port to specify the port on the local host from which syslog messages are
sent. The range is 1 to 65535. The default port is 514.
7. Specify the Source Interface to use for syslog.
Possible values are as follows:
• None. When the None value is displayed, it means that the configured routing
interface has become nonrouting.
• Routing interface
• Routing VLAN
• Routing loopback interface
• T
unnel interface
• Service port
By default, VLAN 1 is used as source interface.
8. Use the USB Filename field to specify the name of the USB file.
The filename cannot
include the following symbols: V:*?”<>!. Up to 64 characters can be entered. The 64
characters are only the filename length, the extension is automatically added. The default
value is blank.
9. Click the Apply button.
Your settings are saved.
Note: Syslog can write the log messages simultaneously to a remote server
and the USB storage device.
Configure the Syslog Host Settings
To configure the syslog host settings:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Monitoring > Logs > Syslog Configuration.