User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Quality of Service User Manual496
secondary (inner) 802.1Q tag of a double VLAN tagged packet. If the packet does
not already contain this header, one is inserted.
• Send.
These packets are presented unmodified by DiffServ to the system
forwarding element.
• Mark IP Precedence.
These packets are marked by DiffServ with the specified IP
Precedence value before being presented to the system forwarding element. This
selection requires that the Mark IP Precedence field be set.
13. If you select Two Rate, you can configure additional fields (same fields as for a simple
policy).
14. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information displayed on the page.
Configure the DiffServ Service Interface
To configure the DiffServ service interface:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select QoS > DiffServ >
Advanced > Service Interface Configuration.
Table 188. DiffServ Policy Configuration - Policy Attribute
Field Description
Policy Name Displays name of the DiffServ policy.
Policy Type Displays type of the policy as In.
Member Class Name Displays name of each class instance within the
policy
.