User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual233
7. The Per VLAN Cost is the path cost from the port to the root bridge.
The values allowed are between 1 and 200,000,000. By default, cost is not configured.
Use the value 0 to unconfigure the setting. If per VLAN cost is not configured, the path
cost value is set based on Link Speed.
8. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information that the PVST/RPVST
Interface Configuration page displays.
View PVST Statistics
You can view and configure Per VLAN Spanning Tree Protocol (PVST)/Per VLAN Rapid
Spanning Tree Protocol (RPVST) Statistics settings for the device.
To view the PVST/RPVST statistics:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching > STP >
Advanced > PVST Statistics.
Table 84. PVST/RPVST Interface Configuration
Field Description
Interface The list of physical interfaces and LAGs.
Role Indicates the role of the interface. Possible values are as follows: Disabled,
Root, Designated,
Alternate, Backup, and Master.
Note: The blank field is displayed for the interface which is not
included for the specified VLAN.
Status Indicates the status of the interface. Possible values are as follows:
Discarding, Learning, Forwarding, and Disabled.
Note: The blank field is displayed for the interface which is not
included for the specified VLAN.