User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual97
7. Select the Conflict Logging mode Disable or Enable radio button.
This specifies whether conflict logging on a DHCP server is to be enabled or disabled.
The default value is Enable.
8. Select the BootP Automatic
mode Disable or Enable radio button.
This specifies whether BootP for dynamic pools is to be enabled or disabled. The default
value is Disable.
9. T
o exclude addresses, do the following:
a. In the IP Range From field, enter the lowest address in the range or a single address
to be excluded.
b. In the IP Range T
o field, to exclude a range, enter the highest address in the range.
To exclude a single address, enter the same IP address as specified in the IP
Range From field, or leave it as 0.0.0.0.
10. Click the Add button.
The exclude addresses are added to the switch
11. Click the Apply button.
Your settings are saved.
Configure the DHCP Pool
To configure the DHCP pool:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select System > Services > DHCP Server > DHCP Pool Configuration.