User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Monitor the Switch and Network User Manual646
5. Select the Admin Status Enable or Disable radio button.
A log that is disabled does not log messages.
6. From the Behavior menu, select the action that occurs when the log is full.
The log can either wrap around (W
rap, which is the default action) or logging can stop
when the log is full (Stop-on-Full).
7. Form the Severity Filter menu, select the severity level:
A log records messages equal to or above a configured severity level. The severity levels
are as follows:
• Emergency (0).
The system is unusable.
• Alert (1).
Action must be taken immediately.
• Critical (2). Critical conditions.
• Error (3). Error conditions.
• Warning (4). W
arning conditions.
• Notice (5). Normal but significant conditions.
• Informational (6). Informational messages.
• Debug (7). Debug-level messages.
8. In the Threshold field, enter the percentage (from 1 to 100 percent) of log space that, if
exceeded, causes logging to stop.
The threshold applies only if the selection from the Behavior menu is Stop-on-Full.
By default, the default the selection from the Behavior menu is W
rap and the threshold
does not apply.
9. Click the Apply button.
Your settings are saved.