User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual225
Configure MST Settings
You can configure Multiple Spanning Tree (MST) on the switch.
To configure an MST instance:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching > STP >
Advanced > MST Configuration.
Topology Change Acknowledge Identifies whether the topology change acknowledgement flag is set for the
next BPDU to be transmitted for this port. It is either True or False.
Edge port Indicates whether the port is enabled as an edge port. It takes the value
Enabled or Disabled.
Point-to-point MAC Derived value of the point-to-point status.
CST Regional Root Bridge Identifier of the CST Regional Root. It is made up using the bridge
priority and the base MAC address of the bridge.
CST Path Cost Path Cost to the CST Regional Root.
Port Up Time Since Counters Last
Cleared
Time since the counters were last cleared, displayed in Days, Hours,
Minutes, and Seconds.
Loop Inconsistent State This parameter identifies whether the port is in loop inconsistent state or
not.
Transitions Into Loop Inconsistent
State
The number of times this interface transitioned into loop inconsistent state.
Transitions Out Of Loop
Inconsistent State
The number of times this interface transitioned out of loop inconsistent
state.
Table 78. CST Port Status (continued)
Field Description