User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Switch Security User Manual599
3. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Security > Control > Captive Portal > CP Client.
5. T
o refresh the page with the latest information on the switch, click the Refresh button.
6. T
o clear the information in the client table, click the Clear button.
The following table describes the nonconfigurable information displayed on the page.t
Set Up and Manage Access Control Lists
Access control lists (ACLs) ensure that only authorized users can access specific resources
while blocking off any unwarranted attempts to reach network resources. ACLs are used to
Table 215. Captive Portal Client
Field Description
MAC Address Shows the client MAC address.
IP Address Drops Identifies the IP address of the client (if applicable).
Protocol Shows the current connection protocol, which is either HTTP or HTTPS.
Verification Shows the current account type, which is Guest, Local, or RADIUS.
Session Time Shows the amount of time that passed since the client was authorized.
Interface Identifies the interface the client is using.
CP ID The ID of the captive portal instance.
User Name The user name (or guest ID) of the connected client.
Bytes Received Total bytes the client received.
Bytes Transmitted Total bytes the client transmitted.
Packets Received Total packets the client received.
Packets Transmitted Total packets the client transmitted.