User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual112
• pim-auto-rp. Relay PIM auto RP (UDP port 496) packets.
• rip. Relay RIP (UDP port 520) packets
• tacacs. Relay
TACACS (UDP port 49) packet
• tftp. Relay
TFTP (UDP port 69) packets
• time. Relay time service (UDP port 37) packets
• Other. If this option is selected, the UDP Port Other V
alue is enabled. This option
permits the user to enter their own UDP port in UDP Port Other Value.
8. Use UDP Port Other V
alue to specify UDP Destination Port that lies between 0 and 65535.
9. Use Discard to enable/disable dropping of matched packets.
Enable can be chosen only when a user enters 0.0.0.0 IP address. Discard mode can be
set to Disable when user adds a new entry with a non-zero IP address.
10. Click the Add button.
An entry with the specified configuration is created in the UDP Relay Table.
11. Click the Apply button.
Your settings are saved.
The Hit Count field displays the number of UDP packets that are detected on the UDP
port.
Manage the DHCPv6 Server
Enable or Disable the DHCPv6 Server
You can configure the Dynamic Host Configuration Protocol for IPv6 (DHCPv6) server
settings on the device. The device can act as a DHCPv6 server or DHCPv6 relay agent to
help assign network configuration information to IPv6 clients.
To enable or disable DHCP service:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select System > Services > DHCPv6 Server > DHCPv6 Server Configuration.