User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Switch Security User Manual534
6. In the Session Timeout field, specify how many minutes of inactivity occur on an inbound
Telnet session before the session is logged off.
You can enter any number from 1 to 160. The factory default is 5 minutes.
7. In the Maximum Number of Sessions field, specify how many simultaneous inbound
T
elnet sessions are allowed.
The maximum is 5, which is also the factory default.
8. Click the Apply button.
Your settings are saved.
The Current Number of Sessions field displays the number of current inbound
Telnet
sessions.
Configure Outbound Telnet
You can regulate new outbound Telnet sessions. If Allow New Telnet Sessions is enabled,
new outbound Telnet sessions can be established until there are no more sessions available.
If Allow New Telnet Sessions is disabled, no new outbound Telnet sessions are established.
An established session remains active until the session is ended or an abnormal network
error ends the session.
To configure outbound Telnet:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Security >
Access > Telnet.