User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Routing User Manual344
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > RIP >
Advanced > Interface Configuration.
5. Use one of the following methods to select an interface:
• In the Go T
o Interface field, enter the interface in the unit/slot/port format and click on
the Go button.
• Next to the Interface column, select the check box for the interface that you want to
configure.
6. From the Send V
ersion list, select the version of RIP control packets that the interface will
send.
The value is one of the following:
• None. No RIP control packets are sent.
• RIP-1. Send RIP version 1 formatted packets through broadcast.
• RIP-1c. RIP version 1–compatibility mode. Send RIP version 2–formatted packets
through broadcast.
• RIP-2. Send RIP version 2 packets using multicast.
The default is RIP-2.
7. From the Receive V
ersion list, select which RIP control packets the interface accepts.
The value is one of the following:
• RIP-1.
Accept only RIP version 1–formatted packets.
• RIP-2.
Accept only RIP version 2–formatted packets.
• Both.
Accept packets in either format. The default is Both.
• None. No RIP control packets are accepted.