User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual209
The global traffic class mapping configuration determines the traffic class used to transmit
iSCSI packets. The traffic mapping configuration options are as follows:
• IEEE 802.1P
• IP-DSCP
The configuration of the CoS component determines changes in the mapping of IEEE
802.1p or IP-DSCP values to traf
fic classes. For more information, see
Manage Class of
Service on page 471.
8. If you are using VLAN Priority as the QoS profile, in the VLAN Priority T
ag field, select the
iSCSI session packets.
The range is 0 to 7. The default is 5.
9. If you are using DSCP as the QoS profile, in the DSCP list, select a value to assign iSCSI
session packets.
The range is 0 to 63. The default is 46.
10. Select the Remark Enable or Disable radio button.
This enables or disables the marking of iSCSI frames with the configured VLAN Priority
tag/DSCP when egressing the switch. Enabling remarks updates the packets with IEEE
802.1p or IP-DSCP values. Remarking packets with priority data provides special QoS
treatment as the packets continue through the network. Remark is enabled by default.
11. In the iSCSI Aging
Time field, set the number of minutes a session can be inactive prior to
If using DSCP as the QoS profile, useremoval.
The iSCSI Aging Time must be a whole number in the range of 1 to 43200 minutes. The
default is 10 minutes.
12. Click the Apply button.
Your settings are saved.
View iSCSI Sessions
To view active iSCSI session information:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. click Switching > iSCSI > Basic > Sessions.