User Manual

Configure System Information

ProSAFE 10-Gigabit Smart Managed Switch XS708T and XS716T User Manual

Configure the Time Settings

The switch supports the Simple Network Time Protocol (SNTP). As its name suggests, it is a

less complicated version of Network Time Protocol, which is a system for synchronizing the

clocks of networked computer systems, primarily when data transfer is handled through the

Internet. You can also set the system time manually.

Configure the Time Setting Manually

Use the Time Configuration page to view and adjust date and time settings.

 To manually configure the time setting:

1. Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or

connect directly to a switch that is off-network using an Ethernet cable.

2. Launch a web browser.

3. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Change the Default IP Address of the

Switch on page 10.

The login window opens.

4. Enter the switch’s password in the Password field.

The default password is password.

The System Information page displays.

5. Select System > Management > Time > Time Configuration.

Neighbor State The state of the neighboring switch:

• reachable (1). The neighbor is reachable by this switch.

• stale (2). Information about the neighbor is scheduled for deletion.

• delay (3). No information was received from the neighbor during

the delay period.

• probe (4). The switch is attempting to probe for this neighbor.

• unknown (5). Unknown status.

Last Updated The last sysUpTime that this neighbor was updated.

Table 12. IPv6 network interface neighbor table information (continued)

Field Description