User Manual

Configure Routing
220
ProSAFE 10-Gigabit Smart Managed Switch XS708T and XS716T User Manual
The following table describes the nonconfigurable information displayed on the page.
Configure Router Discovery
 To configure router discovery:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing> Router Discovery > Router Discovery Configuration.
6. Select a check box to the left of the Interface column to select the router interface.
7. From the Advertise Mode menu, select Enable or Disable.
If you select Enable, router advertisements are transmitted from the selected interface.
8. In the Advertise Address field, specify the IP address that must be advertised.
In the Maximum Advertise Interval field, enter the maximum time (in seconds) allowed
between router advertisements sent from the interface. The default value is 600.
Table 62. VLAN Routing Configuration information
Field Description
Port The interface assigned to the VLAN for routing.
MAC Address The MAC address assigned to the VLAN routing interface.
Routing Mode Displays whether routing is enabled for the VLAN Routing Interface.