User Manual

Get Started
22
ProSAFE 10-Gigabit Smart Managed Switch XS708T and XS716T User Manual
Power LED
The Power LED is a bicolor LED that serves as an indicator of power and diagnostic status:
• Solid green. The power is supplied to the switch and operating normally.
• Solid yellow. The system is in the boot-up stage.
• Off. No power is supplied to the switch.
Fan LED
The Fan LED indicates the following status:
• Solid yellow. The fan is faulty.
• Off. The fan is operating normally.
Interface Naming Conventions
The switch supports physical and logical interfaces. Interfaces are identified by their type and
the interface number. The physical ports are Gigabit interfaces and are numbered on the
front panel. You configure the logical interfaces by using the software.
The following table describes the naming convention for all interfaces available on the switch.
Table 3. Naming conventions for interfaces
Interface Description Example
Physical The physical ports are 10 Gigabit
Ethernet interfaces and are
numbered sequentially starting
from one.
xg1, xg2, xg12
Link aggregation group (LAG) LAG interfaces are logical
interfaces that are used only for
bridging functions.
l1, l2, l3
CPU management interface This is the internal switch interface
responsible for the switch base
MAC address. This interface is not
configurable and is always listed in
the MAC Address Table.
c1
Routing VLAN interfaces This is an interface used for routing
functionality.
VLAN 1, VLAN 2, VLAN 3