Manualshelf

User Manual

ManualsBrandsNETGEAR ManualsComputers & AccessoriesNETGEAR 8-Port 10Gig Gigabit Ethernet Smart Managed Pro Switch, L2+/Layer 3 Lite, 10 SFP+, ProSAFE Lifetime Protection (XS708T)
121122123124125126127128129130
Configure Switching
128
ProSAFE 10-Gigabit Smart Managed Switch XS708T and XS716T User Manual
5. Select Switching > VLAN > Advanced > VLAN Status.
The following table describes the nonconfigurable information displayed on the page.
Configure Port PVID Settings
You can assign a port VLAN ID (PVID) to an interface. The following requirements apply to a
PVID:
• You must define a PVID for all ports.
• If no other value is specified, the default VLAN PVID is used.
• To change the port’s default PVID, you must first create a VLAN that includes the port as
a member.
• Use the Port VLAN ID (PVID) Configuration page to configure a virtual LAN on a port.
To configure PVID settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
Table 31. VLAN status
Field Definition
VLAN ID The VLAN identifier (VID) of the VLAN. The range of the VLAN ID is 1
to 4093.
VLAN Name The name of the VLAN. VLAN ID 1 is always named Default.
VLAN Type The VLAN type:
• Default (VLAN ID = 1). Always present.
• Static. A VLAN that you configured.
• Dynamic. A VLAN created by GVRP registration that you did not
convert to static, and that GVRP can therefore remove.
Routing Interface The interface associated with the VLAN, in the case that VLAN routing
is configured for this VLAN.
Member Ports The ports that are included in the VLAN.