Manualshelf

User Manual

ManualsBrandsNETGEAR ManualsComputers & AccessoriesNETGEAR 8-Port 10Gig Gigabit Ethernet Smart Managed Pro Switch, L2+/Layer 3 Lite, 10 SFP+, ProSAFE Lifetime Protection (XS708T)
101102103104105106107108109110
Configure System Information
106
ProSAFE 10-Gigabit Smart Managed Switch XS708T and XS716T User Manual
the ARP packet equals the destination MAC address. This check applies only to ARP
responses, since the target MAC address is unspecified in ARP requests. You can also
enable IP address checking. When this option is enabled, DAI drops ARP packets with an
invalid IP address. The following IP addresses are considered invalid:
• 0.0.0.0
• 255.255.255.255
• All IP multicast addresses
• All class E addresses (240.0.0.0/4)
• Loopback addresses (in the range 127.0.0.0/8)
The valid IP check is applied only on the sender IP address in ARP packets. In ARP
response packets, the check is applied only on the target IP address.
To configure the optional DAI features:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select System> Services > Dynamic ARP Inspection > DAI Configuration.
6. Next to Validate Source MAC, select the Enable radio button.
7. Next to Validate Destination MAC, select the Enable radio button.
8. Next to Validate IP, select the Enable radio button.
9. Click the Apply button.