Operation Manual

Optimize Performance With Quality of Service
35
ProSAFE 10-Gigabit Ethernet Web Managed Switch
9. To set the port priority for one or more ports, do the following:
a. Select one or more ports.
b. In the Priority section, select the priority by moving the slider.
The default setting is Low Priority(P0).
Click the APPLY button.
Your settings are saved. The same priority is applied to all ports that you selected.
10. To set a different port priority for one or more other ports, repeat Step 9.
Set Up Rate Limiting
You can limit the rate at which the switch accepts incoming data and the rate that it
retransmits outgoing data. The rate choices vary depending on the switch model.
Rate limiting can be set for a port in addition to other QoS settings. If the port rate limit is set,
the switch restricts the acceptance or retransmission of data to the values configured.
Use Browser-Based Access to Set Up Rate Limiting
 To set up rate limiting:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.