User Manual

Managing Device Security
401
M6100 Web Management User Guide
To access the RADIUS Server Configuration page, click Security  Management Security>
RADIUS
 Server Configuration link.
To configure a RADIUS server:
1. T
o add a RADIUS server, specify the settings the following list describes, and click Add.
• In the Radius Server IP
Address field, specify the IP address of the RADIUS server
to add.
• In the Radius Server Name field, specify the Name of the server being added.
• Use Port to specify the UDP port used by this server
. The valid range is 0 - 65535.
• Secret Configured -
The Secret will only be applied if this option is “yes”. If the option
is “no”, anything entered in the Secret field will have no affect and will not be retained.
• Use Secret to specify the shared secret for this server
.
• Use Primary Server to set the selected server as a Primary or Secondary server
.
• Use Message Authenticator to enable or disable the message authenticator attribute
for the selected server
.
2. Click Add to add a new server to the switch.
This button is only available to READWRITE
users. These changes will not be retained across a power cycle unless a save is performed.
3. Click Delete to remove the selected server from the configuration.
This button is only
available to READWRITE users. These changes will not be retained across a power cycle
unless a save is performed.
Field Description
Current Indicates if this server is currently in use as the
authentication server
.
The following table describes the RADIUS server statistics available on the page.
Use the buttons at the bottom of the page to perform the following actions:
• Click Clear Counters to reset the authentication server and RADIUS statistics to their
default values.