User Manual

Routing
320
M6100 Web Management User Guide
4. From the Metric Type list, select the OSPFv3 metric type of redistributed routes
5. Set the Ta
g field in routes redistributed. This field displays the tag if the source was
preconfigured, otherwise the tag is 0 and can be modified. Valid values are 0 to
4294967295.
6. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
7. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
8. Click Update to update the page with the latest information on the switch.
NSF OSPFv3 Summary
Use this screen to see the NSF OSPFv3 Summary. The allowable values for each field are
displayed next to the field. If any invalid values are entered, an alert message is displayed
with the list of all the valid values.
 To display the NSF OSPF Summary page, click Routing > OSPFv3 > Advanced > NSF
OSPFv3 Summary. The following page is displayed.
 Configure the NSF OSPFv3 Summary.
1. From the Support Mode list, configure how the unit performs graceful restarts by
selecting from the following possible values:
• Always — Indicates that OSPF should perform a graceful restart for all planned and
unplanned warm restart events.
• Disabled — Disables OSPF from performing graceful restarts.
• Planned — Indicates that OSPF should only perform a graceful restart when a restart
is planned (for example, due to an initiate failover command).
The default is Disabled.
2. Configure the Restart Interval. V
alid values are 0 to 1800 in seconds. The default is 120
seconds.
3. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.