User Manual

Routing
234
M6100 Web Management User Guide
3. In the ICMPv6 Rate Limit Error Interval field, specify the number of ICMP error packets
allowed per burst interval. This value controls the ICMPv6 error packets. The default Rate
Limit is 100 packets per second, meaning that the burst interval is 1000 mseconds. To
disable ICMP Rate Limiting, set this field to 0.The valid Rate Interval must be in the range 0
to 2147483647 mseconds.
4. In the ICMPv6 Rate Limit Burst Size field, specify the number of ICMP error packets
allowed per burst interval.
This value controls the ICMP error packets. Default burstsize is
100 packets. When burst interval is 0, then configuring this field is not a valid operation.
Valid Burst Size must be in the range of 1 to 200.
5. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
IPv6 Route Table
Use this page to display the IPv6 Route Table.
To display the IPv6 Route Table page, click Routing
 IPv6  Basic  Route Table. The
following page is displayed.
 Select the IPv6 Route Table to display.
1. In the Routes Displayed list, select from the following:
• All Routes — Shows all active Ipv6 routes.
• Best Routes Only — Shows only the best active routes.
• Configured Routes Only — Shows the routes configured by the user.
Table 87, IPv6 Route Table describes the non-configurable data that is displayed.
Click Update to update the page with the latest information on the switch.