User Manual

Configuring Switching Information
183
M6100 Web Management User Guide
Basic
From the Basic link, you can access the following pages:
• MVR Configuration on page 183
MVR Configuration
To display the MVR Configuration page, click Switching > MVR > Basic > MVR
Configuration. A screen similar to the following is displayed.
1. Use MVR Running to Enable or Disable the MVR feature. The factory default is
Disable.
2. Use MVR Multicast VLAN to specify the VLAN on which MVR multicast data will be
received.
All source ports belong to this VLAN. The value can be set in a range of 1 to
4093. The default value is 1.
Field Definition
MVR Max Multicast Groups Displays the maximum number of multicast groups
that MVR supports.
MVR Current Multicast Groups Displays current number of the MVR groups
allocated.
3. Use MVR Global query response time to set the maximum time to wait for the IGMP
reports membership on a receiver port. This time applies only to receiver-port leave
processing. When an IGMP query is sent from a receiver port, the switch waits for the
default or configured MVR query time for an IGMP group membership report before
removing the port from the multicast group membership. The value is equal to the tenths of
second. The range is from 1 to 100 tenths. The factory default is 5 tenths or one-half.
4. Use MVR Mode to specify the MVR mode of operation. Possible values are compatible or
dynamic. The
factory default is compatible.
5. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.