Manualshelf

Installation Guide

ManualsBrandsNETGEAR ManualsComputers & AccessoriesDaughter card to add PoE++ (up to 60W per port) to XCM8948 and XCM8944 blades
11121314151617181920
Table Of Contents
17
5. At the user prompt, log in to the switch using the user name admin
and press Enter. At the password prompt, do not type a password but
press Enter.
You can now use the CLI to manually congure the IP address of the
switch, or to use the ezcong utility, continue with the next step.
Note: For information about CLI management, see the CLI reference
manual.
6. At the next command prompt, type ezcong and press Enter.
The ezcong utility is now running on the switch.
Netgear Switch) #ezcong
EZ Conguration Utility
7. Using ezcong, set up the basic switch conguration, including a static
IP address and subnet mask.
8. Use the switch IP address that is assigned by ezcong to log in to the
switch’s local browser UI.