User Manual

Routing
362
M6100 Web Management User Guide
 IPv6 MLD Routing Interface Configuration
1. In the Go T
o Interface field, enter the interface in unit/slot/port format and click Go. The
entry corresponding to the specified interface is selected.
2. Select the check box beside the Interface for which data is to be displayed or
configured.
3. In the Admin Mode field, select the Enable or Disable option to set the administrative
status of MLD on the selected routing interface.
The default is disable.
4. In the V
ersion field, enter the version you want to configure for the selected interface. Valid
values are 1 to 2. The default value is 2.
5. In the Query Interval field, enter the frequency in seconds at which MLD host-query packets
are to be transmitted on this interface. V
alid values are 1 to 3600. The default value is 125.
6. In the Query Max Response T
ime field, enter the maximum query response time, in
milliseconds, to be advertised in MLDv2 queries on this interface. Valid values are 0 to
65535. The default value is 10000 milliseconds.
7. In the Startup Query Interval field, enter the configured interval in seconds between
general queries sent by a Querier on startup.
The default value is 31.
8. Enter the Startup Query Count value to indicate the configured number of Queries sent out
on startup, separated by the Startup Query Interval.
The default value is 2.
9. In the Last Member Query Interval field, enter the last member query interval in
milliseconds.
This is the maximum response time to be inserted into group-specific queries
sent in response to leave group messages, and is also the amount of time between
group-specific query messages. Valid values are from 0 to 655355. The default value is
1000 milliseconds.
10. In the Last Member Query Count field, enter the number of queries to be sent on receiving
a leave group report. V
alid values are from 1 to 20. The default value is 2.