User Manual

Routing
349
M6100 Web Management User Guide
PIM Interface Configuration
To display the Multicast PIM Interface Configuration page, click Routing Multicast  PIM 
Interface Configuration. The following page is displayed.
 PIM Interface Configuration
1. Select the check box beside the interface for which data is to be configured or
displayed.
2. In the Admin Mode field, select the Enable or Disable option to set the administrative
status of PIM in the router
. The default is disable.
3. In the Hello Interval field, enter the time in seconds between the transmission of PIM Hello
messages on this interface.
The valid values are from 0 to 18000. The default value is 30.
4. In the Join/Prune Interval, enter the time in seconds at which PIM Join/Prune messages
are transmitted on this PIM interface.
The valid values are from 0 to 18000. The default
value is 60.
5. In the BSR Border field, select the Enable or Disable option to set the Bootstrap Router
(BSR) border status on the selected interface.
6. Enter the DR Priority for the selected interface.
The valid values are from 0 to 2147483647.
The default value is 1.
7. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
8. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Table 141, Multicast PIM Interface Configuration on page 349 describes the
non-configurable data that is displayed.
Table 141. Multicast PIM
Field Description
Protocol State The state of PIM in the router — either operational or non-operational.
IP Address The IP address of the selected PIM interface. If you enter an IPv6 address,
the format is Prefix/Prefix Length.
Designated Router The Designated Router on the selected PIM interface.
Neighbor Count The number of PIM neighbors on the selected interface.
Interface Configuration