User Manual

Configuring Switching Information
175
M6100 Web Management User Guide
2. Use Querier IP Address to specify the Snooping Querier Address to be used as source
address in periodic IGMP queries. This address is used when no address is configured on
the VLAN on which query is being sent.
3. Use IGMP V
ersion to specify the IGMP protocol version used in periodic IGMP queries.
The range is 1 to 2. The default value is 2.
4. Use Query Interval(secs) to specify the time interval in seconds between periodic queries
sent by the Snooping Querier
. The Query Interval must be a value in the range of 1 and
1800. The default value is 60.
5. Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the
last Querier information is removed.
The Querier Expiry Interval must be a value in the
range of 60 and 300. The default value is 125.
6. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
7. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Field Description
VLAN IDs Enabled For IGMP Snooping Querier Displays VLAN IDs enabled for IGMP Snooping
Querier
.
IGMP Snooping Querier VLAN Configuration
Use this page to configure IGMP Queriers for use with VLANs on the network.
To access this page, click Switching
 Multicast  IGMP Snooping  Querier VLAN
Configuration.
To configure Querier VLAN settings:
1. T
o create a new VLAN ID for IGMP Snooping, select New Entry from the VLAN ID field
and complete the following fields. User can also set pre-configurable Snooping Querier
parameters.
• VLAN ID - Specifies the VLAN ID for which the IGMP Snooping Querier is to be
enabled.
• Querier Election Participate Mode - Enable or disable Querier Participate Mode.
• Disabled - Upon seeing another Querier of the same version in the VLAN, the
Snooping Querier moves to the non-querier state.