User Manual

Configuring Switching Information
134
M6100 Web Management User Guide
internal VLANs are allocated by port-based routing interface, they cannot be assigned to a
routing VLAN interface.
1. Use Internal VLAN Allocation Base to specify the VLAN Allocation Base for the routing
interface. The default base of the internal VLAN is 1 to 4093.
2. Use the optional Internal VLAN
Allocation Policy field to specify a policy for the internal
VLAN allocation. There are two policies supported: ascending and descending.
VLAN Membership
To display the VLAN Membership page, click Switching VLAN  Advanced  VLAN
Membership.
To configure VLAN membership:
1. Use VLAN ID to select the VLAN ID for which you want to display or configure data.
2. Use Group Operation to select all the ports and configure them:
• Untag All - Select all the ports on which all frames transmitted for this VLAN will be
untagged.
All the ports will be included in the VLAN.
• T
ag All - Select the ports on which all frames transmitted for this VLAN will be tagged.
All the ports will be included in the VLAN.
• Remove All -
All the ports that may be dynamically registered in this VLAN via GVRP.
This selection has the effect of excluding all ports from the selected VLAN.
3. Use Port List to add the ports you selected to this VLAN. Each port has three modes:
• T(T
agged) - Select the ports on which all frames transmitted for this VLAN will be
tagged. The ports that are selected will be included in the VLAN.
• U(Untagged) - Select the ports on which all frames transmitted for this VLAN will be
untagged.
The ports that are selected will be included in the VLAN.
• BLANK(Autodetect) - Select the ports that may be dynamically registered in this
VLAN via GVRP
. This selection has the effect of excluding a port from the selected
VLAN.