User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
542
A
A. Default Settings
This appendix describes the default settings for many of the NETGEAR M6100 Managed
Chassis software features.
Table 162. Default Settings
Feature Default
IP address 169.254.100.100
Subnet mask 255.255.0.0
Default gateway 0.0.0.0
Protocol DHCP
Management VLAN ID 1
Minimum password length Eight characters
IPv6 management mode None
SNTP client Enabled
SNTP server Not configured
Global logging Enabled
CLI command logging Disabled
Console logging Enabled (Severity level: debug and above)
RAM logging Enabled (Severity level: debug and above)
Persistent (FLASH) logging Disabled
DNS Enabled (No servers configured)
SNMP Enabled (SNMPv1/SNMPv2, SNMPv3)
SNMP Traps Enabled
Auto Install Enabled
Auto Save Disabled
sFlow Enabled