User Manual

Maintenance
536
M6100 Web Management User Guide
To configure the Traceroute settings and send probe packets to discover the route to a host
on the network:
1. Use IP Address/Hostname to enter the IP address or Hostname of the station you want
the switch to discover a path. The default value is blank.
2. Enter the number of Probes Per Hop.
The default value is 3. The range is 1 to 10.
3. Enter the Maximum TTL for the destination.
The default value is 30. The range is 1 to 255.
4. Enter the Initial TTL to be used.
The default value is 1. The range is 1 to 255.
5. Enter the Maximum Failures allowed in the session.
The default value is 5. The range is 1
to 255.
6. Interval (secs) - Enter the
Time between probes in seconds. The default value is 3. The
range is 1 to 60.
7. Enter the UDP Destination Port in probe packets.
The default value is 33434. The range is
1- 65535.
8. Enter the Size of the probe packets.
The default value is 0. The range is 0 to 39936.
9. Enter the Source IP address or interface to use when sending the echo request packets. If
source is not required, select None as the source option. Possible values are:
• None — The source address of the ping packet would be the address of the default
outgoing interface.
• IP Address — The source IP address to use when sending the Echo request packets.
This field is shown when IP Address is selected as the source option.
• Interface — The interface to use when sending the Echo request packets. This field is
shown when Interface is selected as the source option.