User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Monitoring the System
518
M6100 Web Management User Guide
3. Use Poller Interval to specify the maximum number of seconds between successive
samples of the counters associated with this data source. A sampling interval of 0 disables
counter sampling. Allowed range is 0 to 86400 seconds.
4. Use Sampler Receiver Index to specify the sFlow Receiver for this flow sampler. If set to 0,
the sampler configuration is set to default and the sampler is deleted. Only active receivers
can be set. If a receiver expires then all samplers associated with the receiver will also
expire. Allowed range is 1 to 8.
5. Use Sampling Rate to specify the statistical sampling rate for packet sampling from this
source. A sampling rate of 1 counts all packets. A sampling rate of 0 disables sampling.
Allowed range is 1024 to 65536.
6. Use Maximum Header Size to specify the maximum number of bytes that should be copied
from a sampled packet. Allowed range is 20 to 256.