User Manual

Routing
335
M6100 Web Management User Guide
 DVMRP Interface Configuration
1. In the Go T
o Interface field, enter the interface in unit/slot/port format and click Go. The
entry corresponding to the specified interface is selected.
2. Select the check box next to the Interface for which data is to be displayed or configured.
3. In the Interface Mode field, select the Enable or Disable option to set the administrative
mode of the selected DVMRP routing interface.
The default is disable.
4. In the Interface Metric field, enter the DVMRP metric for the selected interface.
This value
is sent in DVMRP messages as the cost to reach this network. Valid values are 1 to 31. The
default value is 1.
5. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. Click Update to update the page with the latest information on the switch.
Table 130, DVMRP Interface Configuration describes the non-configurable data that is
displayed.
Table 130. DVMRP Interface Configuration
Field Description
Protocol State The operational state of the DVMRP protocol on the selected interface, either
operational or non-operational.
Local Address The IP address used as a source address in packets sent from the selected
interface.
Generation ID The DVMRP generation ID used by the router for the selected interface. This
value is reset every time an interface is (re)started and is placed in prune
messages.
A change in generation ID informs the neighbor routers that any
previous information about this router should be discarded.
Received Bad Packets The number of invalid packets received on the selected interface.