User Manual

Configuring System Information
40
M6100 Web Management User Guide
8. To change the settings for an existing SNTP server, select the check box next to the
configured server and enter new values in the available fields, then click Apply.
Configuration changes take effect immediately.
9. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
10. To remove an SNTP server entry, select the check box next to the configured server to
remove, and then click Delete. The entry is removed, and the device is updated.
11. Click Update to update the page with the latest information on the switch.
SNTP Server Status
The SNTP Server Status table displays status information about the SNTP servers
configured on your switch.
Table 17, SNTP Server Status displays SNTP Server Status information.
Table 17. SNTP Server Status
Field Description
Address Specifies all the existing Server Addresses. If no Server
configuration exists, a message saying “No SNTP server
exists” flashes on the screen.
Last Update Time Specifies the local date and time (UTC) that the response
from this server was used to update the system clock.
Last Attempt Time Specifies the local date and time (UTC) that this SNTP
server was last queried.
Last Attempt Status Specifies the status of the last SNTP request to this server.
If no packet has been received from this server, a status of
Other is displayed.
• Other - None of the following enumeration values.
• Success - The SNTP operation was successful and the
system time was updated.
• Request Timed Out - A directed SNTP request timed
out without receiving a response from the SNTP server.
• Bad Date Encoded - The time provided by the SNTP
server is not valid.
• Version Not Supported - The SNTP version supported
by the server is not compatible with the version
supported by the client.
• Server Unsynchronized - The SNTP server is not
synchronized with its peers. This is indicated via the
'leap indicator' field on the SNTP message.
• Server Kiss Of Death - The SNTP server indicated that
no further queries were to be sent to this server. This is
indicated by a stratum field equal to 0 in a message
received from a server.