User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring Switching Information
181
M6100 Web Management User Guide
1. Use Querier Admin Mode to select the administrative mode for MLD Snooping for the
switch. The default is disable.
2. Use Querier Address to specify the Snooping Querier
Address to be used as source
address in periodic MLD queries. This address is used when no address is configured on
the VLAN on which query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and
x::x.
3. Use MLD V
ersion to specify the MLD protocol version used in periodic MLD queries. MLD
queries.
4. Use Query Interval(secs) to specify the time interval in seconds between periodic queries
sent by the Snooping Querier
. The Query Interval must be a value in the range of 1 and
1800. The default value is 60.
5. Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the
last Querier information is removed.
The Querier Expiry Interval must be a value in the
range of 60 and 300. The default value is 60.
Field Description
VLAN IDs Enabled For MLD Snooping Querier Displays VLAN IDs enabled for MLD Snooping
Querier
.
MLD Snooping Querier VLAN Configuration
To access the MLD Snooping Querier VLAN Configuration page, click Switching Multicast
MLD Snooping Querier VLAN Configuration.
1. VLAN ID - Specifies the VLAN ID on which MLD Snooping Querier is administratively
enabled and VLAN exists in the VLAN database.