Installation Guide

17
5. At the user prompt, log in to the switch using the user name admin
and press Enter. At the password prompt, do not type a password but
press Enter.
You can now use the CLI to manually congure the IP address of the
switch, or to use the ezcong utility, continue with the next step.
Note: For information about CLI management, see the CLI reference
manual.
6. At the next command prompt, type ezcong and press Enter.
The ezcong utility is now running on the switch.
Netgear Switch) #ezcong
EZ Conguration Utility
7. Using ezcong, set up the basic switch conguration, including a static
IP address and subnet mask.
8. Use the switch IP address that is assigned by ezcong to log in to the
switch’s local browser UI.