Installation Guide

Table Of Contents

• CLI. Use the command-line interface (CLI) through the mini USB

console port or RJ-45 RS232 console port. You can congure the

IP address manually or use the ezcong utility (see Use the CLI to

congure the IP address on page 16).

• DHCP server. Connect a DHCP server through the OOB port or

through any Ethernet network port and nd the assigned IP address

(see Find the IP address assigned by the DHCP server on page 18).

After you congure or nd the IP address of the switch, you can congure

the features of the switch through either the local browser UI or the CLI.

Use the local browser UI to congure the IP address

You can use a computer on the same subnet as the switch to access the

local browser UI over the switch’s default IP address and assign a different

static IP address to the switch.

1. Congure your computer with a static IP address:

• For access over an Ethernet network port, use an IP address in the

169.254.0.0/16 subnet. For example, use 169.254.100.201.

• For access over the OOB port, use an IP address in the

192.168.0.0/16 subnet. For example, use 192.168.0.100.