User Manual

Configuring System Information
47
M6100 Web Management User Guide
Green Ethernet Configuration
You can use this page to configure the Green Ethernet settings for the switch.
To access this page, click System
 Management  Green Ethernet.
To configure the Green Ethernet settings:
1. Use the Auto Power Down Mode radio buttons to enable or disable this option.
The
factory default is enable. When the port link is down the PHY will automatically go down
for short period of time, and then wakes up to check link pulses. This will allow
performing auto-negotiation and saving power consumption when no link partner is
present.
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
3. Click Apply to update the configuration on the switch.
Green Ethernet Interface Configuration
Use this page to configure the Green Ethernet interface settings.
To access this page, click System
 Management  Green Ethernet Green Ethernet
Interface Configuration.
IPv6 NDP Entries The maximum number of IPv6 Neighbor Discovery
Protocol (NDP) cache entries.
IPv6 Unicast Routes The maximum number of IPv6 unicast forwarding
table entries.
ECMP Next Hops The maximum number of next hops that can be
installed in the IPv4 and IPv6 unicast forwarding
tables.
IPv4 Multicast Routes The maximum number of IPv4 multicast forwarding
table entries.
IPv6 Multicast Routes
The maximum number of IPv6 multicast forwarding
table entries.
Field Description