User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Managing Device Security
420
M6100 Web Management User Guide
Telnet Authentication List
This page allows you to select the login and enable authentication list available. The login list
specifies the authentication method(s) you want to use to validate switch or port access for
the users associated with the list. The enable list specifies the authentication method(s) you
want to use to validate privileged EXEC access for the users associated with the list. These
lists can be created through the Authentication List link under Management Security.
1. Use Login Authentication
List to specify which authentication list to use login through
telnet. The default value is networkList.
2. Use Enable Authentication
List to specify which authentication list you are using when
going into the privileged EXEC mode. The default value is enableNetList.
Inbound Telnet
This page regulates new telnet sessions. If Allow New Telnet Sessions is enabled, new
inbound telnet sessions can be established until there are no more sessions available. If
Allow New Telnet Sessions is disabled, no new inbound telnet sessions are established. An
established session remains active until the session is ended or an abnormal network error
ends the session.
1. Use Allow New T
elnet Sessions to specify whether the new Inbound Telnet session is
Enabled or Disabled. Default value is Enabled.