User Manual

Configuring Switching Information
142
M6100 Web Management User Guide
6. Use Authentication Mode to configure the authentication mode for the selected interface.
The default is Enable. When authentication mode is enabled, then voice traffic is allowed on
an unauthorized Voice VLAN port. When authentication mode is disabled, then devices are
authorized through dot1x.
Note: Authentication through dot1x is possible only if dot1x is enabled.
7. Use DSCP V
alue to configure the Voice VLAN DSCP value for the port. The valid range is
0 to 64. The default value is 0.
Table 70 describes the non-configurable Voice VLAN Configuration field.
Table 70. Voice VLAN Configuration
Field Description
Operational State This is the operational status of the Voice VLAN on
the given interface.
GARP Switch Configuration
Note: It can take up to 10 seconds for GARP configuration changes to take
effect.
To display the GARP Switch Configuration page, click Switching
 VLAN  Advanced 
GARP Switch Configuration.
1. Use GVRP Mode to choose the GARP VLAN Registration Protocol administrative mode
for the switch by selecting enable or disable from the radio button. The factory default is
disable.
2. Use GMRP Mode to choose the GARP Multicast Registration Protocol administrative mode
for the switch by selecting enable or disable from the radio button.
The factory default is
disable.