User Manual

Configuring System Information
114
M6100 Web Management User Guide
Table 60. LLDP-MED Global Configuration
Field Description
Device Class Specifies local device's MED Classification. There
are four dif
ferent kinds of devices, three of them
represent the actual end points (classified as Class I
Generic [IP Communication Controller etc.], Class II
Media [Conference Bridge etc.], Class III
Communication [IP Telephone etc.]). The fourth
device is Network Connectivity Device, which is
typically a LAN Switch/Router, IEEE 802.1 Bridge,
IEEE 802.11 Wireless Access Point etc.
LLDP-MED Interface Configuration
To display this page, click System  LLDP  LLDP-MED  Interface Configuration. A screen
similar to the following is displayed.
1. Use Go To Port to enter the Port in unit/slot/port format and click on the Go button. The
entry corresponding to the specified Port, will be selected.
2. Use Interface to specify the list of ports on which LLDP-MED - 802.1AB can be configured.
3. Use MED Status to specify whether LLDP-MED mode is enabled or disabled on this
interface.
4. Use Notification Status to specify the LLDP-MED topology notification mode of the
interface.
5. Use T
ransmit Type Length Values to specify which optional type length values (TLVs) in
the LLDP-MED will be transmitted in the LLDP PDUs frames for the selected interface:
• MED Capabilities -
To transmit the capabilities TLV in LLDP frames.
• Network Policy -
To transmit the network policy TLV in LLDP frames.
• Location Identification -
To transmit the location TLV in LLDP frames.
• Extended Power via MDI - PSE -
To transmit the extended PSE TLV in LLDP frames.
• Extended Power via MDI - PD -
To transmit the extended PD TLV in LLDP frames.
• Inventory Information -
To transmit the inventory TLV in LLDP frames.
The following table describes the LLDP-MED Interface Configuration fields.