User Manual

Configuring System Information
91
M6100 Web Management User Guide
 To display Power Matrix:
1. Click System > Chassis >
Advanced > Chassis Power Configuration.
Figure 22. Power Matrix
The following table describes the non-configurable Power Matrix data that is displayed.
Table 49. Power Matrix
Field Description
Blade Type The 4-bit identification number assigned to a blade.
Blade Model Blade model.
Power Required Maximum consumption by blade in watts (excluding PoE power).
Chassis Power Configuration
Figure 23. Rebalance Chassis Power
 To rebalance the chassis power:
1. Click System > Chassis >
Advanced > Chassis Power Rebalance.
2. Click the checkbox.
3. Click the
Apply button to power down the low priority PD device until enough power is
obtained to power up new blade or higher priority PoE port on different blade.
Chassis Firmware Synchronization
 To configure Chassis Firmware Synchronization:
1. Click System
 Chassis > Advanced > Chassis Firmware Synchronization.
2. In the Chassis Firmware
Auto Upgrade field, specify whether the Firmware Synchronization
feature is Enabled or Disabled. The default is Disabled.
3. In the
Traps field, Enable or Disable the sending of traps during Chassis Firmware
Synchronization Start, Failure, and Finish. The default is Enabled.
4. In the
Allow Downgrade field, Enable or Disable downgrading the image on a chassis
member if the chassis member’s version is newer. The default is Enabled.