User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Maintenance
520
M6100 Web Management User Guide
Auto Install Configuration
To access the Auto Install Configuration page, click Maintenance Save Config Auto Install
Configuration.
1. Use Auto Install to select the start/stop auto install mode on the switch.
2. Use AutoInstall Persistent Mode to enable/disable
AutoInstall persistent mode.
3. Use AutoSave Mode to select Enabled/Disabled and click the
Apply button to have
configuration changes you have made saved across a system reboot. All changes submitted
since the previous save or system reboot will be retained by the switch.
4. Use AutoInstall Retry Count to specify the number of times the unicast
TFTP tries should
be made for the DHCP specified file before falling back for broadcast TFTP tries.
Field Description
AutoInstall State Displays the current status of the AutoInstall process.
Reset
The Reset menu contains links to the following options:
• Device Reboot on page 520
• Power Cycle on page 521
• Factory Default on page 521
• Password Reset on page 522
Device Reboot
Use the Device Reboot page to reboot M6100 Chassis switch.
To access the Device Reboot page, click Maintenance
Reset Device Reboot.