User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Routing
296
M6100 Web Management User Guide
OSPFv3 Configuration
To display the Default Route Advertise Configuration page, click Routing > OSPFv3 >
Advanced > OSPFv3 Configuration. The following page is displayed.
Configure the Default Route Advertise Configuration settings.
1. In the Default Information Originate field, select to Enable or Disable Default Route
Advertise. Default Information Originate is Disabled by default.
Note: The values for Always, Metric, and Metric Type can only be
configured after Default Information Originate is set to enable. If
Default Information Originate is set to enable, and values for
Always, Metric, and Metric Type are already configured, then setting
Default Information Originate back to disable will set the Always,
Metric, and Metric Type values to the default.
2. In the Always field, select T
rue or False. When set to True, this field sets the router
advertise. The default is False.
3. In the Metric field, specify the metric of the default route. V
alid values range from 0 to
16777214. The default is 0.
4. In the Metric T
ype field, select the OSPFv3 metric type of the default route. Two types are
supported: External Type 1 and External Type 2. The default is External Type 2.
5. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.