User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Routing
289
M6100 Web Management User Guide
The key value will only be displayed if you are logged on with Read/Write privileges,
otherwise it will be displayed as asterisks.
9. In the Authentication ID field, enter the ID to be used for authentication. You will only be
prompted to enter an ID when you select Encrypt as the authentication type. The ID is a
number between 0 and 255, inclusive.
10. Click Add to add a new virtual link to the switch.
11. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
12. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
13. Click Delete to remove the specified virtual link from the switch configuration.
Table 109, OSPF Virtual Link Configuration on page 290 describes the non-configurable
data that is displayed.