User Manual

Routing
260
M6100 Web Management User Guide
Table 97. RIP Advanced Interface Configuration
Field Description
Bad Packets Received The number of RIP response packets received by the RIP process which
were subsequently discarded for any reason.
Bad Routes Received The number of routes, in valid RIP packets, which were ignored for any
reason (for example, unknown address family
, or invalid metric).
Updates Sent The number of triggered RIP updates actually sent on this interface. This
explicitly does not include full updates sent containing new information.
IP Address The IP Address of the router interface.
Link State Indicates whether the RIP interface is up or down.
Route Redistribution
Use this screen to configure the RIP Route Redistribution parameters. The allowable values
for each field are displayed next to the field. If any invalid values are entered, an alert
message is displayed with the list of all the valid values.
 To display the Advanced RIP Route Redistribution Configuration page, click Routing > RIP >
Advanced > Route Redistribution. The following page is displayed.
 Configure the Advanced RIP Route Redistribution Configuration settings.
1. The Source list is populated by only those source routes that have already been configured
for redistribution by RIP
. This allows you to configure another source route among the
available source routes. Valid values are:
• Connected
• Static
• OSPF
2. From the Redistribute Mode list, select to Enable or Disable RIP Redistribute Mode.
The
default is disable.
3. Enter the Metric of redistributed routes for the given source route. V
alid value for the Metric
is 0 to 15; 0 means unconfigure.
4. Use the Distribute List field to set the
Access List that filters the routes to be redistributed
by the destination protocol. Only permitted routes are redistributed. If this command refers to