User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Routing
217
M6100 Web Management User Guide
IP
The Routing IP folder contains links to the following web pages that configure and display
IP routing data:
• Basic on page 217
• Advanced on page 223
Basic
From the Routing IP > Basic link, you can access the following pages:
• IP Configuration on page 217
• Statistics on page 218
IP Configuration
Use this menu to configure routing parameters for the switch, as opposed to an interface.
To display the IP Configuration page, click Routing
IP Basic IP Configuration.
1. Use Routing Mode to select enable or disable. You must enable routing for the switch
before you can route through any of the interfaces. The default value is disable.
2. Use ICMP Echo Replies to select enable or disable. If it is enable then only the router can
send ECHO replies. By default ICMP Echo Replies are sent for echo requests.
3. Use ICMP Redirects to select enable or disable. If it is enabled globally and on interface
level then only the router can send ICMP Redirects.
4. Use ICMP Rate Limit Interval to control the ICMP error packets by specifying the number
of ICMP error packets that are allowed per burst interval. By default, Rate limit is 100
packets/sec i.e., burst interval is 1000 msec.
To disable ICMP Rate limiting, set this field to
'0'. Valid Rate Interval must be in the range 0 to 2147483647.