User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring Switching Information
133
M6100 Web Management User Guide
• Protocol Based VLAN Group Membership on page 139
• IP Subnet Based VLAN on page 139
• Port DVLAN Configuration on page 140
• Voice VLAN Configuration on page 141
• GARP Switch Configuration on page 142
• GARP Port Configuration on page 143
VLAN Configuration
To display the VLAN Configuration page, click Switching VLAN Advanced VLAN
Configuration.
Reset Configuration - If you select this button and confirm your selection on the next screen,
all VLAN configuration parameters will be reset to their factory default values. Also, all
VLANs, except for the default VLAN, will be deleted. The factory default values are:
• All ports are assigned to the default VLAN of 1.
• All ports are configured with a PVID of 1.
• All ports are configured to an
Acceptable Frame Types value of Admit All Frames.
• All ports are configured with Ingress Filtering disabled.
• All ports are configured to transmit only untagged frames.
• GVRP is disabled on all ports and all dynamic entries are cleared.
Internal VLAN Configuration
This page displays the allocation base and the allocation mode of internal VLAN. The internal
VLAN is reserved by port-based routing interface and invisible to the end user
. Once these