User Manual

Monitoring the System
505
M6100 Web Management User Guide
Cable Test
To display the Cable Test page, click Monitoring  Ports> Cable Test.
1. Port - Indicates the interface to which the cable to be tested is connected.
2. Click Apply to perform a cable test on the selected interface.
The cable test may take up to
2 seconds to complete. If the port has an active link, the cable status is always 'Normal'. The
command returns a cable length estimate if this feature is supported by the PHY for the
current link speed. Note that if the link is down and a cable is attached to a 10/100 Ethernet
EAPOL Logoff Frames
Received
This displays the number of EAPOL logoff frames that have been received
by this authenticator.
EAPOL Last Frame Version This displays the protocol version number carried in the most recently
received EAPOL frame.
EAPOL Last Frame Source This displays the source MAC address carried in the most recently received
EAPOL frame.
EAPOL Invalid Frames
T
ransmitted
This displays the number of EAPOL frames that have been received by this
authenticator in which the frame type is not recognized.
EAPOL Length Error Frames
Received
This displays the number of EAPOL frames that have been received by this
authenticator in which the frame type is not recognized.
EAP Response/ID Frames
Received
This displays the number of EAP response/identity frames that have been
received by this authenticator
.
EAP Response Frames
Received
This displays the number of valid EAP response frames (other than resp/id
frames) that have been received by this authenticator
.
EAP Request/ID Frames
T
ransmitted
This displays the number of EAP request/identity frames that have been
transmitted by this authenticator.
EAP Request Frames
T
ransmitted
This displays the number of EAP request frames (other than request/identity
frames) that have been transmitted by this authenticator.
Field Description