User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Managing Device Security
457
M6100 Web Management User Guide
Dynamic ARP Inspection
The Dynamic ARP Inspection (DAI) link contains links to the following pages:
• DAI Configuration on page 457
• DAI VLAN Configuration on page 457
• DAI Interface Configuration on page 458
• DAI ACL Configuration on page 459
• DAI ACL Rule Configuration on page 460
• DAI Statistics on page 460
DAI Configuration
To display the DAI Configuration page, click Security Control> Dynamic ARP Inspection
DAI Configuration.
1. Use Validate Source MAC to choose the DAI Source MAC Validation Mode for the
switch by selecting Enable or Disable radio button. If you select Enable, Sender MAC
validation for the ARP packets will be enabled. The factory default is disable.
2. Use V
alidate Destination MAC to choose the DAI Destination MAC Validation Mode for the
switch by selecting Enable or Disable radio button. If you select Enable, Destination MAC
validation for the ARP Response packets will be enabled. The factory default is disable.
3. Use V
alidate IP to choose the DAI IP Validation Mode for the switch by selecting Enable or
Disable radio button. If you select Enable, IP Address validation for the ARP packets will be
enabled. The factory default is disable.
DAI VLAN Configuration
To display the DAI VLAN Configuration page, click Security Control> Dynamic ARP
Inspection
DAI VLAN Configuration.